Guts Seat Cover For Yozma IN10/IN10 Pro/ Tasaca T500/T500 Pro

Stock seats get slick the second you pin it. Instant e-moto torque slides you off the back, and your arms end up doing the seat’s job. A GUTS Racing gripper cover fixes that.

GUTS cuts this cover for the seat — not stretched to “fit a few bikes.” Same gripper vinyl factory MX teams run, sewn in California. Ribs give you a physical stop under throttle. The diamond-texture top keeps you planted in wet, dust, and heat. Heavy stitching holds up to mud, sun, and abuse.

Why it matters

•  Locks you in on launches, wheelies, and hard corners

•  Race-proven gripper material — more bite than stock vinyl

•  Ribbed layout so you stay where you sit

•  Weather- and fade-resistant

•  Lightweight, stretches even, installs over the stock foam

Install

Cover only. Remove the stock cover and staple this one onto the existing foam and pan. Staple gun + 8–10 mm stainless staples. About 30 minutes.

Notes

•  Cover only — foam and pan not included

•  Confirm your exact bike/seat before ordering (Yozma IN10 / Tasaca V58 / other — match the listing)

•  Don’t hit gripper vinyl with silicone sprays; they kill the texture

•  Clean with mild soap, water, and a soft brush